RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Viewing a List of WAN Interfaces 153
Section 3.24.1
Viewing a List of WAN Interfaces
To view a list of WAN interfaces, navigate to interface » wan. The WAN Slot Port Settings table appears.
Figure 159: WAN Slot Port Settings Table
Section 3.24.2
Configuring a WAN Interface
To configure a WAN interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » wan » {interface}, where {interface} is the WAN interface. The Enable WAN
Interface form appears.
Figure 160: Enable WAN Interface Form
1. Enabled Check Box 2. Link Alarms Check Box 3. Alias Box
3. Configure the following parameter(s) as required:
Parameter Description
enabled Default: false
Enables this WAN port.
link-alarms Default: true
To Next Page
Loading...
