Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
628
Managing the Encapsulated Security Payload (ESP)
Protocol
Figure 732: Algorithm Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen algorithm.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.28.8
Managing the Encapsulated Security Payload (ESP) Protocol
The Encapsulated Security Payload (ESP) employed by IPsec provides encryption and authentication, making
sure that messages originated from the expected sender have not been altered in transit.
The following sections describe how to configure and manage the ESP protocol:
• Section 5.28.8.1, “Configuring ESP Encryption”
• Section 5.28.8.2, “Viewing a List of ESP Algorithms”
• Section 5.28.8.3, “Adding ESP Algorithms”
• Section 5.28.8.4, “Deleting ESP Algorithms”
Section 5.28.8.1
Configuring ESP Encryption
To configure the encryption algorithm for the Encapsulate Security Payload (ESP), do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » ipsec » connection » {connection} » esp, where {connection} is the name of the
connection. The ESP Encryption Algorithm form appears.
To Next Page
Loading...
