Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
654 Viewing the Generic Tunnel Statistics
Section 5.29.7.1
Viewing the Generic Tunnel Statistics
To view the generic tunnel statistics, navigate to tunnel » l2tunneld » status » generic. The Generic L2 Tunnel
Statistics form appears.
Figure 768: Generic L2 Tunnel Statistics Form
1. Tunnel Name 2. Interface Name 3. RX Frames 4. TX Frames 5. RX Characters 6. TX Characters 7. Errors
This table provides the following information:
Parameter Description
tunnel-name The generic tunnel name.
Section 5.29.7.2
Viewing a List of Generic Tunnels
To view a list of generic tunnels, navigate to tunnel » l2tunneld » generic. If tunnels have been configured, the
Generic L2 Tunnel Protocol table appears.
Figure 769: Generic L2 Tunnel Protocol Table
If no generic tunnels have been configured, add tunnels as needed. For more information, refer to
Section 5.29.7.3, “Adding a Generic Tunnel”.
Section 5.29.7.3
Adding a Generic Tunnel
To configure a generic tunnel, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to tunnel » l2tunneld » generic and click <Add tunnel>. The Key Settings form appears.
To Next Page
Loading...
