RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing the Status of LDP Binding 813
• Section 5.39.7.1, “Viewing the Status of LDP Binding”
• Section 5.39.7.2, “Viewing the Status of the LDP Discovery Interfaces”
• Section 5.39.7.3, “Viewing the Status of the LDP Neighbor Local Node Information”
• Section 5.39.7.4, “Viewing the Status of the LDP Neighbor Connection Information”
• Section 5.39.7.5, “Viewing the Status of the LDP Neighbor Discovery Information”
• Section 5.39.7.6, “Configuring LDP”
• Section 5.39.7.7, “Configuring Neighbor Discovery”
• Section 5.39.7.8, “Viewing a List of LDP Interfaces”
• Section 5.39.7.9, “Enabling/Disabling an LDP Interface”
Section 5.39.7.1
Viewing the Status of LDP Binding
To view the status of the LDP binding on the device, navigate to mpls » ldp » status » binding. If LDP interfaces
have been configured, the LDP Binding Status Information table appears.
Figure 939: LDP Binding Status Information Table
This table provides the following information:
Parameter Description
Prefix The LDP transport prefix.
Local Label The incoming (local) label.
Next Hop The destination next hop router.
Remote Label The LDP remote label.
In Use The LDP in-use flag.
To Next Page
Loading...
