Siemens RX1500

Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
452 Deleting an Excluded Autonomous System Path Filter
3. Click Delete next to the chosen filter.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.19.4.6
Deleting an Excluded Autonomous System Path Filter
To delete an excluded autonomous system path filter from a BGP route map entry, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » bgp » filter » route-map » {name} » entry » {number} » set » as-path »
exclude, where {name} is the name of the route map and {number} is the entry number. The AS Path to
Exclude table appears.
1 2 3
Figure 505: AS Path to Exclude Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen filter.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.19.5
Managing Prefix Lists and Entries
Neighbors can be associated with prefix lists, which allow the BGP daemon to filter incoming or outgoing routes
based on the allow and deny entries in the prefix list.
The following sections describe how to configure and manage prefix lists and entries for dynamic BGP routes:
• Section 5.19.5.1, “Viewing a List of Prefix Lists”
• Section 5.19.5.2, “Viewing a List of Prefix Entries”
• Section 5.19.5.3, “Adding a Prefix List”
• Section 5.19.5.4, “Adding a Prefix Entry”
• Section 5.19.5.5, “Deleting a Prefix List”