Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
556 Viewing a List of PIM-SM Interfaces
Figure 647: PIM-SM Configuration Form
1. Enable PIM-SM Check Box 2. Default Preference Box 3. Default Metric Box 4. Broken Cisco Checksum Check Box
3. Configure the following parameters as required:
Parameter Description
Enable PIM-SM Enable PIM-SM service.
Default Preference Default: 1024
Default preference value. Preferences are used by assert elections to determine
upstream routers.
Default Metric Default: 1024
Default metric value. Metric is the cost of sending data through interface.
Broken Cisco Checksum If your RP is a cisco and shows many PIM_REGISTER checksum errors from this
router, setting this option will help.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.24.3
Viewing a List of PIM-SM Interfaces
To view a list of PIM-SM interfaces, navigate to routing » multicast » dynamic » pim-sm » interface. If PIM-SM
interfaces have been configured, the Interface table appears.
To Next Page
Loading...
