RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an IP Range From a Subnet 355
Figure 386: IP Range Configuration Form
1. End Box
6. Configure the following parameter(s) as required:
Parameter Description
end The ending IP address pool that the server uses to offer to the client.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.15.14.3
Deleting an IP Range From a Subnet
To delete an IP range from a DHCP subnet, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver » subnet » {name} » options » iprange, where {name} is the name of
the subnet. The IP Range Configuration table appears.
Figure 387: IP Range Configuration Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen IP range.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
To Next Page
Loading...
