Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
176 Deleting a Virtual Switch
Parameter Description
Enabled Default: true
Enables this interface.
Forward Delay Default: 15
Delay (in seconds) of the listening and learning state before goes to forwarding state.
Alias The SNMP alias name of the interface
IP Address Source Synopsis: static, dynamic
Default: static
Whether the IP address is static or dynamically assigned via DHCP or BOOTP.
ProxyARP Enables/Disables whether the port will respond to ARP requests for hosts other than
itself
6. Add interfaces for the virtual switch. For more information, refer to Section 3.25.4.2, “Adding a Virtual Switch
Interface”.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 3.25.3
Deleting a Virtual Switch
To delete a virtual switch, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » virtualswitch. The Virtual Switch table appears.
Figure 186: Virtual Switch Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen switch.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
To Next Page
Loading...
