Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
280 Configuring the System Time and Date
8. If required, add server authentication keys. For more information, refer to Section 5.12.13.2, “Adding a
Server Key”.
9. Add restrictions for the remote NTP servers. For more information, refer to Section 5.12.14.2, “Adding a
Server Restriction”.
10. Enable the NTP service. For more information, refer to Section 5.12.7, “Enabling/Disabling the NTP Service”.
11. View the status of the NTP service. For more information, refer to Section 5.12.8, “Viewing the NTP Service
Status”.
Section 5.12.2
Configuring the System Time and Date
To configure the system time and date, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin and click set-system-clock in the menu. The Set New Time and Date and Trigger
Action forms appear.
Figure 288: Set New Time and Date Form
1. Time Box
Figure 289: Trigger Action Form
1. Perform Button
3. On the Set New Time and Date form, configure the following parameter(s) as required:
Parameter Description
time Enter the date and time in the format YYYY-MM-DD HH:MM:SS.
To Next Page
Loading...
