RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an SNMP Group 277
Figure 286: SNMP Group Access Configuration Form
1. Read View Name List 2. Write View Name List 3. Notify View Name List
5. Configure the following parameter(s) as required:
Parameter Description
Read View Name Synopsis: no-view, v1-mib, restricted, all-of-mib
Default: all-of-mib
The name of the read view to which the SNMP group has access: all-of-mib, restricted,
v1-mib, or no-view.
Write View Name Synopsis: no-view, v1-mib, restricted, all-of-mib
Default: all-of-mib
The name of the write view to which the SNMP group has access: all-of-mib, restricted,
v1-mib, or no-view.
Notify View Name Synopsis: no-view, v1-mib, restricted, all-of-mib
Default: all-of-mib
The name of the notification view to which the SNMP group has access: all-of-mib,
restricted, v1-mib, or no-view.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.11.9.3
Deleting an SNMP Group
To delete an SNMP group, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » snmp » snmp-group. The SNMP Group Access Configuration table appears.
To Next Page
Loading...
