Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
458 Viewing a List of Autonomous System Path Entries
Figure 514: Autonomous System Path Filter Table
If no filters have been configured, add filters as needed. For more information, refer to Section 5.19.6.3, “Adding
an Autonomous System Path Filter”.
Section 5.19.6.2
Viewing a List of Autonomous System Path Entries
To view a list of entries for an autonomous system path filter, navigate to routing » dynamic » bgp » filter » as-
path » {name} » entry, where {name} is the name of the autonomous system path filter. If entries have been
configured, the Entry table appears.
Figure 515: Entry Table
If no filters have been configured, add filters as needed. For more information, refer to Section 5.19.6.3, “Adding
an Autonomous System Path Filter”.
Section 5.19.6.3
Adding an Autonomous System Path Filter
To add an autonomous system path filter for dynamic BGP routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » bgp » filter » as-path and click <Add as-path>. The Key Settings form
appears.
To Next Page
Loading...
