RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of Custom Client Options 331
Section 5.15.8.1
Viewing a List of Custom Client Options
To view a list of custom client options configured for a DHCP subnet, navigate to services » dhcpserver »
subnet » {name} » options » client » custom, where {name} is the name of the subnet. The Custom
Configuration table appears.
Figure 353: Custom Configuration Table
If no custom client options have been configured, add options as needed. For more information, refer to
Section 5.15.8.2, “Adding a Custom Client Option”.
Section 5.15.8.2
Adding a Custom Client Option
To add a custom client option to a DHCP subnet, do the following:
NOTE
The number of the option (defined by the Internet Assigned Numbers Authority or IANA) and its
allowed value must be known before this custom option can be configured. For more information about
DHCP options, refer to RFC 2132 [http://tools.ietf.org/html/rfc2132].
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver » subnet » {name} » options » client » custom, where {name} is the
name of the subnet.
3. Click <Add custom>. The Key Settings form appears.
To Next Page
Loading...
