Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
484 Deleting a Prefix List
Parameter Description
Action Synopsis: deny, permit
Default: permit
The action that will be performed.
Network The IPv4 network address and prefix.
Less Than or Equal to The maximum prefix length to be matched.
Greater Than or Equal to The minimum prefix length to be matched.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.20.3.5
Deleting a Prefix List
To delete a prefix list for dynamic RIP routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » rip » filter. The Prefix List table appears.
Figure 550: Prefix List Table
1. Add Button 2. Edit Button 3. Delete Button
NOTE
Deleting a prefix list removes all associate prefix entries as well.
3. Click Delete next to the chosen prefix list.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
To Next Page
Loading...
