Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
134 Viewing a List of Ethernet Trunk Interfaces
• Section 3.22.2, “Adding an Ethernet Trunk Interface”
• Section 3.22.3, “Deleting an Ethernet Trunk Interface”
• Section 3.22.4, “Managing Ethernet Trunk Ports”
Section 3.22.1
Viewing a List of Ethernet Trunk Interfaces
To view a list of Ethernet trunk interfaces, navigate to interface » trunks. If trunks have been configured, the
Ethernet Trunk Interfaces table appears.
Figure 135: Ethernet Trunk Interfaces Table
If no Ethernet trunk interfaces have been configured, add trunks as needed. For more information, refer to
Section 3.22.2, “Adding an Ethernet Trunk Interface”.
Section 3.22.2
Adding an Ethernet Trunk Interface
To add an Ethernet trunk interface, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » trunks and click <Add trunks>. The Key Settings form appears.
Figure 136: Key Settings Form
1. Trunk ID Box 2. Add Button
3. Configure the following parameter(s) as required:
To Next Page
Loading...
