Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
528 Adding an Incoming Route Filter
Section 5.21.7.2
Adding an Incoming Route Filter
To add a route filter for incoming advertised routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Make sure a route map has been configured. For more information, refer to Section 5.21.6, “Managing Route
Maps”
3. Navigate to routing » dynamic » ospf » incoming-route-filter and click <Add incoming-route-filter>. The
Key Settings form appears.
Figure 610: Key Settings Form
1. Route Map List 2. Add Button
4. Click Add to create the new incoming route filter.
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.21.7.3
Deleting an Incoming Route Filter
To delete a route filter configured for incoming advertised routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » ospf » incoming-route-filter. The Incoming Route Filter table appears.
To Next Page
Loading...
