Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
324 Viewing a List of Subnets
Section 5.15.7.1
Viewing a List of Subnets
To view a list of subnets, navigate to services » dhcpserver » subnet. If subnets have been configured, the
Subnet Configuration table appears.
Figure 344: Subnet Configuration Table
If no subnets have been configured, add subnets as needed. For more information, refer to Section 5.15.7.2,
“Adding a Subnet”.
Section 5.15.7.2
Adding a Subnet
To add a subnet to the DHCP server, do the following:
NOTE
Make sure a shared network is configured before adding a new subnet. For information about
configuring a shared network, refer to Section 5.15.6.2, “Adding a Shared Network”.
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver » subnet and click <Add subnet> in the menu. The Key Settings form
appears.
Figure 345: Key Settings Form
1. Name Box 2. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
name The unique name to refer to the host within a DHCP configuration.
To Next Page
Loading...
