Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
422 Deleting an LSP Generation Interval
Parameter Description
The IS type for this setting, specified as level-1-only, level-2-only or level-1-2.
4. Click Add to create the new interval. The LSP Generic Interval Routing Type form appears.
Figure 461: LSP Generic Interval Routing Type Form
1. Interval Box
5. Configure the following parameter(s) as required:
Parameter Description
Interval Minimum interval in seconds, ranging from 1 to 120. Default is 30.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.18.6.3
Deleting an LSP Generation Interval
To delete an LSP generation interval for an IS-IS area, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » isis » area » {name} » lsp-gen-interval, where {name} is the unique
name for a routing process that belongs to a specific router. The LSP Generic Interval Routing Type table
appears.
Figure 462: LSP Generic Interval Routing Type
1. Add Button 2. Edit Button 3. Delete Button
To Next Page
Loading...
