RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an Autonomous System Path 461
Section 5.19.6.5
Deleting an Autonomous System Path
To delete an autonomous system path filter for dynamic BGP routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » bgp » filter » as-path. The Autonomous System Path Filter table
appears.
Figure 518: Autonomous System Path Filter Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen filter.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.19.6.6
Deleting an Autonomous System Path Filter Entry
To delete an entry for an autonomous system path filter, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » bgp » filter » as-path » {name} » entry, where {name} is the name of the
autonomous system path filter. The Entry table appears.
To Next Page
Loading...
