Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
354 Viewing a List of IP Ranges for Subnets
Section 5.15.14.1
Viewing a List of IP Ranges for Subnets
To view a list of IP ranges configured for a DHCP subnet, navigate to services » dhcpserver » subnet »
{name} » options » iprange, where {name} is the name of the subnet. If ranges have been configured, the IP
Range Configuration table appears.
Figure 384: IP Range Configuration Table
If no IP ranges have been configured, add ranges as needed. For more information, refer to Section 5.15.14.2,
“Adding an IP Range to a DHCP Subnet”.
Section 5.15.14.2
Adding an IP Range to a DHCP Subnet
To add an IP range to a DHCP subnet, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver » subnet » {name} » options » iprange, where {name} is the name of
the subnet.
3. Click <Add iprange>. The Key Settings form appears.
Figure 385: Key Settings Form
1. Start Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter Description
start The starting IP address pool that the server uses to offer to the client.
5. Click Add to create the IP range. The IP Range Configuration form appears.
To Next Page
Loading...
