RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Deleting a Remote Server Selector 55
Parameter Description
negate Excludes messages defined in the Remote Server Selector fields from the log. Selecting
this option acts as a logical NOT for the selector definition.
For example: Selecting same, debug, and mail in the Comparison, Level, and Facility-
list fields includes debug messages from the mail subsystem in the log. Selecting
Negate excludes debug messages from the mail subsystem from the log.
comparison Synopsis: same_or_higher, same
Default: same_or_higher
The message severity levels to include in the log:
• same: includes only messages of the severity level selected in the Level field.
• same_or_higher: includes messages of the severity level selected in the Level field,
and all messages of higher severity.
For example:
• Selecting debug in the Level field and same in the Comparison field includes only
debug messages in the log.
• Selecting debug in the Level field and same_or_higher in the Comparison field
includes debug and all higher severity messages in the log.
level Synopsis: emerg, alert, crit, err, warning, notice, info, debug, none, all
Default: all
The base message severity level to include in the log. all includes all messages. none
excludes all messages. Other levels are listed in order of increasing severity.
facility-list Synopsis: auth, authpriv, cron, daemon, ftp, kern, lpr, mail, news, security, syslog,
user, uucp, local0, local1, local2, local3, local4, local5, local6, local7, all
Synopsis: "facility-list" occurs in an array of at least 1 and at most 8 elements
The subsystems generating log messages. Messages from the selected subusystems
are included in the log. At least one subsystem must be selected; up to 8 subsystems
can be selected.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 3.9.5.3
Deleting a Remote Server Selector
To delete a remote server selector, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » logging » server » {address} » selector, where {address} is the IP address of the
remote server. The Remote Server Selector table appears.
To Next Page
Loading...
