Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
542 Managing Gateways for Static Routes
Parameter Description
The distance for this static route's blackhole. Default is 1.
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.22.6
Managing Gateways for Static Routes
The following sections describe how to configure and manage gateways for static routes:
• Section 5.22.6.1, “Configuring Gateways for IPv6 Static Routes”
• Section 5.22.6.2, “Viewing a List of Gateways for IPv4 Static Routes”
• Section 5.22.6.3, “Adding a Gateway for an IPv4 Static Route”
• Section 5.22.6.4, “Deleting a Gateway for an IPv4 Static Route”
Section 5.22.6.1
Configuring Gateways for IPv6 Static Routes
To configure a gateway address for an IPv6 static route, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » static » ipv6 » {subnet}, where subnet is the subnet (network/prefix) of the static
route.
3. Click the + symbol in the menu next to via. The Static Route Using Gateway form appears
Figure 629: Static Route Using Gateway Form
1. Gateway Address Box 2. Distance Box
4. Configure the following parameter(s) as required:
Parameter Description
Gateway Address The gateway for the static route.
To Next Page
Loading...
