RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Managing the Prefix List Distribution 493
Figure 561: Neighbor Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen neighbor.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.20.8
Managing the Prefix List Distribution
The following sections describe how to configure and manage the prefix list distribution:
• Section 5.20.8.1, “Viewing a List of Prefix List Distribution Paths”
• Section 5.20.8.2, “Adding a Prefix List Distribution Path”
• Section 5.20.8.3, “Deleting a Prefix List Distribution Path”
Section 5.20.8.1
Viewing a List of Prefix List Distribution Paths
To view a list of prefix list distribution paths for dynamic RIP routes, navigate to routing » dynamic » rip »
distribute-prefix-list. If distribution paths have been configured, the Distribute Prefix List table appears.
Figure 562: Distribute Prefix List Table
If no prefix list distribution paths have been configured, add distribution paths as needed. For more information,
refer to Section 5.20.8.2, “Adding a Prefix List Distribution Path”.
To Next Page
Loading...
