Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
296 Viewing a List of Server Restrictions
• Section 5.12.14.1, “Viewing a List of Server Restrictions”
• Section 5.12.14.2, “Adding a Server Restriction”
• Section 5.12.14.3, “Deleting a Server Restriction”
Section 5.12.14.1
Viewing a List of Server Restrictions
To view a list of NTP server restrictions, navigate to services » time » ntp » restrict. If restrictions have been
configured, the Server Restrictions table appears.
Figure 310: Server Restrictions Table
If no server restrictions have been configured, add restrictions as needed. For more information, refer to
Section 5.12.14.2, “Adding a Server Restriction”.
Section 5.12.14.2
Adding a Server Restriction
To add an NTP server restriction, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » time » ntp » restrict and click <Add restrict>. The Key Settings form appears.
Figure 311: Key Settings Form
1. Address Box 2. Mask Box 3. Add Button
3. Configure the following parameter(s) as required:
To Next Page
Loading...
