Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
272 Deleting an SNMP User
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 5.11.7.3
Deleting an SNMP User
To delete an SNMP user, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » snmp » snmp-user. The SNMPv3 User Configuration table appears.
Figure 279: SNMPv3 User Configuration Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen user.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.11.8
Managing SNMP Security Model Mapping
The following sections describe how to configure and manage SNMP security models:
• Section 5.11.8.1, “Viewing a List of SNMP Security Models”
• Section 5.11.8.2, “Adding an SNMP Security Model”
• Section 5.11.8.3, “Deleting an SNMP Security Model”
Section 5.11.8.1
Viewing a List of SNMP Security Models
To view a list of SNMP security models configured on the device, navigate to admin » snmp » snmp-security-
to-group. If security models have been configured, the SNMP Security Model to Group Mapping table
appears.
To Next Page
Loading...
