Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
64 Stopping/Declining a Software Upgrade
Parameter Description
Phase 2: Package Download (%
complete)
Phase 2 of the upgrade downloads all packages that require an update. This reflects the
estimated percentage complete.
Phase 3: Package Installation (%
complete)
Phase 3 of the upgrade installs all packages that require an update. This reflects the
estimated percentage complete.
Last Attempt The date and time of the completion of the last upgrade attempt.
Last Result Synopsis: Upgrade Successful, Upgrade Failed, Unknown, Reboot Pending, Not
Applicable, Declined, Interrupted
Indicates whether or not the last upgrade was completed successfully
6. If the software upgrade is successful, reboot the device or decline the software upgrade. For more
information about rebooting the device, refer to Section 3.5, “Rebooting the Device”.
Section 3.11.4
Stopping/Declining a Software Upgrade
To stop/decline a recent software upgrade and revert back to the previously installed version, do the following:
IMPORTANT!
A software upgrade can only be declined before the device is rebooted. If the software upgrade has
already been activated following a reboot, the previous software version installed on the other partition
can be activated. For more information, refer to Section 3.11.5.1, “Rolling Back a Software Upgrade”.
1. Navigate to admin » software-upgrade and click decline-upgrade in the menu. The Trigger Action form
appears.
Figure 56: Trigger Action Form
1. Perform Button
2. Click Perform.
Section 3.11.5
Downgrading the ROX II Software
The ROX II software can be downgraded to a previous release at any time.
The following sections describe the various methods for downgrading the ROX II software:
To Next Page
Loading...
Need help?
General
