Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
496 Viewing a List of Key Chains
• Section 5.20.9.5, “Deleting a Key Chain”
• Section 5.20.9.6, “Deleting a Key”
Section 5.20.9.1
Viewing a List of Key Chains
To view a list of key chains for dynamic RIP routes, navigate to routing » dynamic » rip » key-chain. If key
chains have been configured, the Key Chain Management table appears.
Figure 566: Key Chain Management Table
If no key chains have been configured, add key chains as needed. For more information, refer to
Section 5.20.9.3, “Adding a Key Chain”.
Section 5.20.9.2
Viewing a List of Keys
To view a list of keys in a key chain, navigate to routing » dynamic » rip » key-chain » {name} » key, where
{name} is the name of the key chain. If keys have been configured, the Key Configuration table appears.
Figure 567: Key Configuration Table
If no keys have been configured, add keys as needed. For more information, refer to Section 5.20.9.4, “Adding a
Key”.
Section 5.20.9.3
Adding a Key Chain
To add a key chain for dynamic RIP routes, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » rip » key-chain and click <Add key-chain>. The Key Settings form
appears.
To Next Page
Loading...
