RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an SNMP Target Address 269
Section 5.11.6.3
Deleting an SNMP Target Address
To delete an SNMP target address, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to admin » snmp » snmp-target-address. The SNMPv3 Target Configuration table appears.
Figure 275: SNMPv3 Target Configuration Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen target address.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 5.11.7
Managing SNMP Users
The following sections describe how to configure and manage SNMP users:
• Section 5.11.7.1, “Viewing a List of SNMP Users”
• Section 5.11.7.2, “Adding an SNMP User”
• Section 5.11.7.3, “Deleting an SNMP User”
Section 5.11.7.1
Viewing a List of SNMP Users
To view a list of SNMP users configured on the device, navigate to admin » snmp » snmp-user. If security
models have been configured, the SNMP User Configuration table appears.
To Next Page
Loading...
Need help?
General
