Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
814 Viewing the Status of the LDP Discovery Interfaces
Section 5.39.7.2
Viewing the Status of the LDP Discovery Interfaces
To view the status of the LDP discovery interfaces on the device, navigate to mpls » ldp » status » discovery »
interfaces. If LDP interfaces have been configured, the LDP Discovery Interfaces Status Information table
appears.
Figure 940: LDP Discovery Interfaces Status Information Table
This table provides the following information:
Parameter Description
Interface The LDP discovery interface.
Src IP Addr The LDP discovery source IP address.
Peer ID The LDP discovery peer ID.
Peer IP LDP discovery peer IP address
State The LDP discovery interface state.
For more information about configuring LDP discovery interfaces, refer to Section 5.39.7.9, “Enabling/Disabling
an LDP Interface”.
Section 5.39.7.3
Viewing the Status of the LDP Neighbor Local Node Information
To view the status of the local node(s) for the LDP neighbor on the device, navigate to mpls » ldp » status »
neighbor » local-node-information. The LDP Neighbor Local Node Status Information table appears.
Figure 941: LDP Neighbor Local Node Status Information Table
This table provides the following information:
Parameter Description
LDP ID The LDP ID of the LDP neighbor local node.
Holdtime LDP holdtime of the neighbor local node.
To Next Page
Loading...
