RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Deleting an IP Range From an IP Pool 357
Figure 389: Key Settings Form
1. Start Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter Description
start The starting IP address pool that the server uses to offer to the client.
5. Click Add to create the IP range. The IP Range Configuration form appears.
Figure 390: IP Range Configuration Form
1. End Box
6. Configure the following parameter(s) as required:
Parameter Description
end The ending IP address pool that the server uses to offer to the client.
7. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
8. Click Exit Transaction or continue making changes.
Section 5.15.15.3
Deleting an IP Range From an IP Pool
To delete an IP range from an IP Pool, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
To Next Page
Loading...
