RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of IP Pools 351
Section 5.15.13.1
Viewing a List of IP Pools
To view a list of IP pools configured for a DHCP subnet, navigate to services » dhcpserver » subnet »
{name} » options » ippool, where {name} is the name of the subnet. If pools have been configured, the IP Pool
Configuration table appears.
Figure 379: IP Pool Configuration Table
If no IP pools have been configured, add pools as needed. For more information, refer to Section 5.15.13.2,
“Adding an IP Pool”.
Section 5.15.13.2
Adding an IP Pool
To add an IP pool to a DHCP subnet, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to services » dhcpserver » subnet » {name} » options » ippool, where {name} is the name of
the subnet.
3. Click <Add ippool>. The Key Settings form appears.
Figure 380: Key Settings Form
1. Description Box 2. Add Button
4. Configure the following parameter(s) as required:
Parameter Description
description Describes the IP pool.
5. Click Add to create the IP pool. The Leased Configuration and IP Pool Configuration forms appear.
To Next Page
Loading...
