Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
352 Adding an IP Pool
Figure 381: Leased Configuration Form
1. Default Box 2. Maximum Box
Figure 382: IP Pool Configuration Form
1. Unknown Client Box 2. Failover Peer Box
6. On the Leased Configuration form, configure the following parameter(s) as required:
Parameter Description
default Default: 600
The minimum leased time in seconds that the server offers to the client.
maximum Default: 7200
The maximum leased time in seconds that the server offers to the clients.
7. On the IP Pool Configuration form, configure the following parameter(s) as required:
Parameter Description
unknown-client Synopsis: allow, deny, ignore
The action to take for previously unregistered clients
failover-peer The IP address of a DHCP peer server if a failover pool is created.
8. Add one or more IP ranges for the pool. For more information, refer to Section 5.15.15.2, “Adding an IP
Range to an IP Pool”.
To Next Page
Loading...
