RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Managing Serial Port Protocols 119
1. Navigate to interfaces » serial » port » {slot/port}, where {slot/port} is the slot name and port number of the
serial port.
2. Click reset in the menu. The Trigger Action form appears.
Figure 121: Trigger Action Form
1. Perform Button
3. Click Perform.
Section 3.21
Managing Serial Port Protocols
The following sections describe how to configure and manage serial port protocols:
• Section 3.21.1, “Raw Socket Concepts”
• Section 3.21.2, “Modbus TCP Concepts”
• Section 3.21.3, “DNP Concepts”
• Section 3.21.4, “Viewing a List of Serial Port Protocols”
• Section 3.21.5, “Adding a Serial Port Protocol”
• Section 3.21.6, “Configuring the DNP Protocol”
• Section 3.21.7, “Configuring the Modbus TCP Protocol”
• Section 3.21.8, “Configuring the Raw Socket Protocol”
• Section 3.21.9, “Deleting a Serial Port Protocol”
• Section 3.21.10, “Managing Device Address Tables”
• Section 3.21.11, “Managing Remote Hosts”
Section 3.21.1
Raw Socket Concepts
The raw socket protocol transports streams of characters from one serial port on the device to a specified remote
IP address and port. The raw socket protocol supports TCP and UDP transport.
To Next Page
Loading...
