RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Viewing a List of Redistribution Metrics 433
external metric. This puts external metrics in the range of 64 to 128, even though the metric value defined is only
in the range of 0 to 63.
There is no default metric for IS-IS. A metric should be defined for each routing protocol, otherwise a metric value
of zero (0) is automatically applied.
The following sections describe how to configure and manage redistribution metrics for IS-IS:
• Section 5.18.11.1, “Viewing a List of Redistribution Metrics”
• Section 5.18.11.2, “Adding a Redistribution Metric”
• Section 5.18.11.3, “Deleting a Redistribution Metric”
Section 5.18.11.1
Viewing a List of Redistribution Metrics
To view a list of redistribution metrics defined for an IS-IS area, navigate to routing » dynamic » isis » area »
{name} » redistribute, where {name} is the unique name for the area. The Redistribute table appears.
Figure 478: Redistribute Table
If no redistribution metrics have been configured, add metrics as needed. For more information, refer to
Section 5.18.11.2, “Adding a Redistribution Metric”.
Section 5.18.11.2
Adding a Redistribution Metric
To add a redistribution metric for an IS-IS area, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » isis » area » {name} » redistribute, where {name} is the unique name for
the area.
3. Click <Add redistribute>. The Key Settings form appears.
To Next Page
Loading...
