Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
490 Adding a Network Interface
Section 5.20.6.2
Adding a Network Interface
To add an interface for a RIP network, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » rip » network » interface and click <Add interface>. The Key Settings
form appears.
Figure 557: Key Settings Form
1. Interface Name List 2. Add Button
3. Configure the following parameter(s) as required:
Parameter Description
Interface Name Interface name.
4. Click Add to add the interface.
5. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
6. Click Exit Transaction or continue making changes.
Section 5.20.6.3
Deleting a Network Interface
To delete an interface from a RIP network, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to routing » dynamic » rip » network » interface. The Interface table appears.
To Next Page
Loading...
