RUGGEDCOM ROX II
User Guide
Chapter 3
Device Management
Deleting a Remote Host 133
4. Configure the following parameter(s) as required:
Parameter Description
remote-ip The IP address of the remote host.
remote-port The transport port of the remote host.
5. Click Add to create the remote host.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
7. Click Exit Transaction or continue making changes.
Section 3.21.11.3
Deleting a Remote Host
To delete a remote host, do the following:
1. Change the mode to Edit Private or Edit Exclusive.
2. Navigate to interface » serial » {slot/port} » protocols » rawsocket » setrawsocket » remote-host,
where {slot/port} is the slot name and port number of the serial port. The Remote Host Configuration table
appears.
Figure 134: Remote Host Configuration Table
1. Add Button 2. Edit Button 3. Delete Button
3. Click Delete next to the chosen host.
4. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
5. Click Exit Transaction or continue making changes.
Section 3.22
Managing Ethernet Trunk Interfaces
The following sections describe how to configure and manage Ethernet trunk interfaces:
• Section 3.22.1, “Viewing a List of Ethernet Trunk Interfaces”
To Next Page
Loading...
