Siemens RX1500

RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Configuring BGP 437
1
2
3
4
5
6
Figure 483: BGP Configuration
1. Enable BGP Check Box 2. Autonomous System ID Box 3. Always Compare MED Check Box 4. Default Local Preference
Box 5. Deterministic MED Check Box 6. Router ID Box
3. In the Distance form, configure the following parameters:
Parameter Description
External Routes Distance Distance value for external routes.
Prerequisite: external, internal and local must all be empty or all be configured.
Internal Routes Distance Distance value for internal routes.
Prerequisite: external, internal and local must all be empty or all be configured.
Local Routes Distance Distance value for local routes.
Prerequisite: external, internal and local must all be empty or all be configured.
4. In the BGP Configuration form, configure the following parameters:
Parameter Description
Enable BGP Enables BGP.
Autonomous System ID Autonomous System ID.
Always compare MED Always comparing MED from different neighbors.
Default Local Preference Default: 100
Default local preference value.
Deterministic Med Pick the best-MED path among paths advertised from neighboring AS.