Chapter 5
Setup and Configuration
RUGGEDCOM ROX II
User Guide
586 Adding a VRRP Tracker
Figure 680: Tracker Form
1. Tracker Type List 2. Network Box 3. Interface List 4. Interval List 5. Weight Box 6. Rise Box 7. Fall Box
5. Configure the following parameter(s) as required:
Parameter Description
Track Type Synopsis: route
Default: route
The type of condition for the tracker to check.
Network The network to track. The tracker checks for a route to this network in the routing table.
Interface The interface to the tracked network. The tracker rises only when the route to the
monitored network is through this interface.
Interval The number of seconds between tracker queries.
Weight The amount by which to increase or decrease the router's priority. When negative, the
priority decreases by this amount when the tracker falls. When positive, the priority
increases by this amount when the tracker rises. When not set, the state changes to the
fault state when the tracker falls.
Rise The number of successful tracker queries before changing the router priority.
Fall The number of unsuccessful tracker queries before changing the router priority.
6. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
To Next Page
Loading...
