RUGGEDCOM ROX II
User Guide
Chapter 5
Setup and Configuration
Adding an IPv6 Network Prefix 799
Figure 920: Prefix Form
1. Off Link Check Box 2. No Autoconfig Check Box 3. Set Router Address Flag Check Box
6. On the Lifetime form, configure the following parameter(s) as required:
Parameter Description
Valid Lifetime Synopsis: infinite
The length of time in seconds during which time the prefix is valid for the purpose of on-
link determination.
Prerequisite: The valid lifetime cannot be configured unless the preferred lifetime is
configured.
Preferred Lifetime Synopsis: infinite
The length of time in seconds during which addresses generated from the prefix remain
preferred.
Prerequisite: The preferred lifetime cannot be configured unless the valid lifetime is
configured.
7. On the Prefix form, configure the following parameter(s) as required:
Parameter Description
Off Link Indicates that advertisement makes no statement about on-link or off-link properties of
the prefix.
No Autoconfig Indicates to hosts on the local link that the specified prefix cannot be used for IPv6
autoconfiguration.
Set Router Address Flag Indicates to hosts on the local link that the specified prefix contains a complete IP
address by setting the R flag.
Prerequisite: The router address can not be set unless off-link or no-autoconfig are
set.
8. Click Commit to save the changes or click Revert All to abort. A confirmation dialog box appears. Click OK
to proceed.
9. Click Exit Transaction or continue making changes.
To Next Page
Loading...
