Chapter 3
Device Management
RUGGEDCOM ROX II
User Guide
62 Upgrading the ROX II Software
1. If the source of the software is a USB Mass Storage drive, insert the drive in the USB port on the device.
2. Make sure the source of the software upgrade has been configured. For more information, refer to
Section 3.11.1, “Configuring the Upgrade Source”.
3. Change the mode to Edit Private or Edit Exclusive.
4. Navigate to admin » software-upgrade and click launch-upgrade in the menu. The Trigger Action form
appears.
Figure 54: Trigger Action Form
1. Perform Button
5. Click Perform. The upgrade process beings.
To monitor the real-time progress of the software upgrade, navigate to admin » software-upgrade and view
the Upgrade Monitoring form.
To Next Page
Loading...
