Getting started
R&S
®
RTE
100User Manual 1326.1032.02 ─ 20
7. Select the "Test Definition" tab.
8. Select channel 1 as the "Source".
9. Define the number of tolerable sample hits in the "Tolerance" field.
A test has failed if the number of sample hits exceeds the limit of "Violation toler-
ance" hits.
10. Select the "Event Action / Reset" tab.
11. For the "Stop acquisition" action, select On violation. If the violation tolerance is
exceeded, acquisition stops.
The results of the mask test are shown in the "MaskTest" results box. Mask hits are
also indicated as red points in the mask segment in the diagram.
Trying out the instrument
To Next Page
Loading...
