Rohde & Schwarz RTE - Search on Decoded I²C Data

Protocol analysis
R&S
®
RTE
535User Manual 1326.1032.02 ─ 20
Column Description
Values Value of all data bytes of the frame. The data format
is selected below the table.
Bit rate Value of the bit rate
Zooming on decoded results
The zoom functions allow you to analyze the decode results in more detail. If "Zoom
coupling" is enabled, the decode zoom and result table are synchronized; if you select
a row in the result table, this result is shown in the decode zoom.
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 280
●
Chapter 7.1.3, "Zooming for details", on page 284
Data format
You can select various data formats for the values displayed in the decode table and in
the combs of the decoded signal.
Remote command:
●
BUS<m>:FORMat on page 1422
Export of decode results
1. In the protocol decode table, press "Export".
The "Numeric Results" dialog opens.
For details, see Chapter 12.2.4, "Numeric Results", on page 492.
2. Select the decode results you want to export, the file format, and the delimiter.
3. Tap "Save" or "Save as".
Remote commands
Remote commands are described in Chapter 18.17.3.3, "Decode results",
on page 1434.
13.2.6 Search on decoded I²C data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 445.
I²C (option R&S
RTE-K1)