Rohde & Schwarz RTE - Conventions Used in Remote Command Description; Remote Control Commands

Remote control commands
R&S
®
RTE
1053User Manual 1326.1032.02 ─ 20
18 Remote control commands
This chapter describes all remote commands available for R&S RTE and provides
examples and information how to use the commands.
For further information on remote control, see Chapter 17.5, "Remote control",
on page 1040.
● Conventions used in remote command description............................................ 1053
● Finding the appropriate command...................................................................... 1054
● Programming examples...................................................................................... 1054
● Frequently used parameters and suffixes...........................................................1072
● Common commands...........................................................................................1076
● General remote settings......................................................................................1081
● Instrument setup................................................................................................. 1085
● Acquisition and setup.......................................................................................... 1106
● Trigger................................................................................................................. 1164
● Waveform analysis.............................................................................................. 1211
● Cursor measurements.........................................................................................1238
● Automatic measurements................................................................................... 1249
● Spectrum analysis...............................................................................................1315
● Mask testing........................................................................................................1331
● Search.................................................................................................................1351
● Data management...............................................................................................1389
● Protocols............................................................................................................. 1419
● Mixed signal option (MSO, R&S RTE-B1)...........................................................1900
● Waveform generator (option R&S RTE-B6)........................................................ 1923
● Power analysis (option R&S RTE-K31)...............................................................1943
● Maintenance........................................................................................................1982
● Status reporting...................................................................................................1985
● Remote trace.......................................................................................................1989
● Deprecated commands.......................................................................................1993
18.1 Conventions used in remote command description
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Conventions used in remote command description