Rohde & Schwarz RTE - Track Settings in Protocol Setup

Protocol analysis
R&S
®
RTE
653User Manual 1326.1032.02 ─ 20
6. By default, the track is displayed using "Continuous auto scale". If you want to
change the scaling, proceed as follows:
a) Select the "Result Analysis" tab.
b) Disable "Continuous auto scale".
c) Adjust "Vertical scale" and "Vertical offset".
13.8.5.2 Track settings in protocol setup
You can enable the track waveforms in the protocol display settings. As the track is
based on measurement, you can use the "Measurement" dialog box alternatively, see
Chapter 13.8.5.4, "Track enabling in measurement setup", on page 655.
Access: [PROTOCOL] > "Display" tab
To set the vertical scale of the track waveform, use the measurement scale settings on
the "Measurements" > "Result Analysis" tab, see "Analysis scale" on page 389.
Show Track Waveform(s)
Enables and displays the tracks for the selected channels of the decoded bus using
continuous auto scale.
Audio signals (option R&S
RTE-K5)