Getting started
R&S
®
RTE
110User Manual 1326.1032.02 ─ 20
Histogram and histogram area (9, 10)
A histogram shows the frequency of occurrence of voltage or time values in a bar chart
directly in the diagram. The rectangular histogram area indicates the part of the wave-
form that is considered in the histogram. The vertical histogram counts the voltage val-
ues, and the horizontal histogram counts time values. You can switch between vertical
and horizontal mode, and modify the histogram area by dragging the rectangle as a
whole, by dragging its edges, or by setting exact positions.
Messages (11)
A yellow or red button on the toolbar points to the status messages of the instrument.
To open the message box, tap the button. See also: Chapter 3.4.11, "Messages",
on page 130.
3.4.2.2 Control elements on the touchscreen
The touchscreen provides everything you need to control the instrument, to analyze
waveforms, and to get measurement results. Figure 3-6 shows the control elements on
a glance.
Figure 3-6: Control elements on the touchscreen
1 = Toolbar
2 = Signal bar
3 = Menu bar
4 = Result box (docked)
Operating the instrument
To Next Page
Loading...
