Remote control commands
R&S
®
RTE
1121User Manual 1326.1032.02 ─ 20
Parameters:
<Impedance> Range: 0.1 to 100E+3
Increment: 1
*RST: 50
Default unit: Ohm
Usage: Asynchronous command
CHANnel<m>:OVERload <Overload>
Retrieves the overload status of the specified channel from the status bit. When the
overload problem is solved, the command resets the status bit.
The overload status is returned asynchronously. Therefore, it is not possible to assign
an overload to a specific acquisition during continuous acquisition. This assignment is
only possible for a single acquisition.
Suffix:
<m>
.
1..4
Selects the input channel.
Parameters:
<Overload> ON | OFF
Use OFF to reset the overload status bit.
*RST: OFF
Example:
ACQuire:COUNt 1
SINGle
CHANnel2:OVERload?
Queries the overload status of channel 2 after a single acquisi-
tion.
CHANnel2:OVERload OFF
Resets the overload status bit.
Usage: Asynchronous command
18.8.6 Waveform data
To set the export data format, see FORMat[:DATA] on page 1082.
CHANnel<m>[:WAVeform<n>]:DATA:HEADer?............................................................... 1121
CHANnel<m>[:WAVeform<n>]:DATA[:VALues]?.............................................................. 1122
CHANnel<m>[:WAVeform<n>]:DATA:HEADer?
Returns the header of channel waveform data.
Table 18-1: Header data
Position Meaning Example
1 XStart in s -9.477E-008 = - 94,77 ns
2 XStop in s 9.477E-008 = 94,77 ns
Acquisition and setup
To Next Page
Loading...
