Rohde & Schwarz RTE - Configuring the Search Results Presentation

Search functions
R&S
®
RTE
466User Manual 1326.1032.02 ─ 20
Horizontal ← Search zoom window
Defines whether absolute or relative values are used to specify the x-axis values.
Remote command:
LAYout:ZOOM:HORZ:MODE on page 1213
SEARch:RESDiagram:HORZ:MODE on page 1385
Position / Relative position (horizontal) ← Search zoom window
Defines the x-value of the centerpoint of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:POSition on page 1214
LAYout:ZOOM:HORZ:RELative:POSition on page 1215
SEARch:RESDiagram:HORZ:ABSolute:POSition on page 1384
SEARch:RESDiagram:HORZ:RELative:POSition on page 1385
Range / Relative Range (vertical) ← Search zoom window
Defines the width of the zoom area.
Remote command:
LAYout:ZOOM:HORZ:ABSolute:SPAN on page 1214
LAYout:ZOOM:HORZ:RELative:SPAN on page 1215
SEARch:RESDiagram:HORZ:ABSolute:SPAN on page 1384
SEARch:RESDiagram:HORZ:RELative:SPAN on page 1385
11.4.2 Configuring the search results presentation
Initially, the "Search Results" box is displayed in front of the other diagrams or as result
icon on the signal bar. This depends on the default setting in the "Diagram Layout" tab.
Alternatively, you can display it in its own area on the screen, like any other diagram.
For details, see Chapter 3.4.8, "Displaying results", on page 124.
To configure the result tables
1. Press the [SEARCH] key to open the "Search" dialog box.
2. Select the tab for the search you want to configure.
3. Select the "Result Presentation" tab.
4. Select "Show result table" to display the "Search Results" box.
5. Select the sort mode of the result table.
6. By default, the results are listed in descending order, i.e. the largest value at the
top. To change the sorting direction, enable "Sort ascending".
7. Define a maximum number of results to be displayed in the result table in the "Max
result count" field.
To display search zoom windows
1. In the "Search Results" box, select "Show search zoom windows".
Result presentation