Getting started
R&S
®
RTE
74User Manual 1326.1032.02 ─ 20
For these first measurements, you use the internal calibration signal, so you do not
need any additional signal source or instruments. Try out the following:
● Displaying a basic signal.........................................................................................74
● Acquiring data......................................................................................................... 76
● Changing the waveform scaling and position..........................................................77
● Zooming into the display......................................................................................... 81
● Displaying the waveform history............................................................................. 84
● Showing basic measurement results...................................................................... 86
● Performing a basic FFT analysis.............................................................................93
● Performing mathematical calculations.................................................................... 95
● Performing a search................................................................................................96
● Performing a mask test........................................................................................... 98
● Printing and saving screenshots........................................................................... 101
● Saving data........................................................................................................... 103
3.3.1 Displaying a basic signal
Displaying the input from a signal channel is simple and straightforward. Furthermore,
you get to know some basic trigger functions. The R&S RTE provides wide-ranging
trigger functions to find various signal anomalies, which are described in the instrument
help and in the "User Manual".
1. Press the [PRESET] key on the front panel (in the [SETUP] area on the left).
2. Connect the probe to the input connector [CH 1].
Connect the probe's ground connector to the right compensation pin
, and the tip
to the left pin .
The instrument recognizes the probe, and a signal is displayed in the diagram.
3. Press the [AUTOSET] key on the front panel (in the [SETUP] area on the left).
Autoset finds appropriate horizontal and vertical scales and trigger conditions to
present a stable square waveform. The trigger is set to edge trigger on rising edge
with auto trigger mode.
Trying out the instrument
To Next Page
Loading...
