Search functions
R&S
®
RTE
461User Manual 1326.1032.02 ─ 20
Note: A-event copy, gating and noise reject are not available for search on serial
buses.
11.3 Search gate
The gate defines the search area within the source waveform. You can use absolute or
relative values to define the gate, or couple it to a previously defined zoom area.
11.3.1 Gate settings
Access: [SEARCH] > "Gate" tab
The search gate settings are identical to those for gate areas for measurements or FFT
analysis.
Gating is not available if the search source is a digital channel or a serial bus.
Use gate
Enables the gate settings and shows the gate. Search is only performed on the defined
gate area of the source waveform.
Remote command:
SEARch:GATE[:STATe] on page 1379
Show gate
Displays the gate area in the source diagram.
Remote command:
SEARch:GATE:SHOW on page 1380
Mode
Defines whether the gate settings are configured using absolute or relative values.
"Absolute"
The gate is defined by absolute start and stop values.
Search gate
To Next Page
Loading...
