Rohde & Schwarz RTE - Instrument Setup; System Setup

Remote control commands
R&S
®
RTE
1085User Manual 1326.1032.02 ─ 20
Parameters:
<DispMessState> ON | OFF
*RST: OFF
Firmware/software: Version 2.70
SYSTem:DISPlay:MESSage[:TEXT] <DisplayMessage>
Defines an additional text that is displayed during remote control operation.
To enable the text display, use SYSTem:DISPlay:MESSage:STATe on page 1084.
Parameters:
<DisplayMessage> String that contains the text.
Firmware/software: Version 2.70
18.7
Instrument setup
This chapter describes commands related to SETUP > "System" and "File" > "Exit".
For commands related to SETUP > "Remote Settings", see Chapter 18.6, "General
remote settings", on page 1081.
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 18.3, "Programming examples", on page 1054
● System setup...................................................................................................... 1085
● Display settings...................................................................................................1089
● External application.............................................................................................1106
18.7.1 System setup
SYSTem:EXIT
Starts the shutdown of the firmware.
Usage:
Event
Instrument setup