Rohde & Schwarz RTE - Decode Results

Remote control commands
R&S
®
RTE
1639User Manual 1326.1032.02 ─ 20
TRIGger<m>:ARINc:SDI <SDI>
Sets the source/destination identifier (SDI) bits.
Parameters:
<SDI>
TRIGger<m>:ARINc:SSM <SSM>
Sets the sign/status matrix (SSM) bits.
Parameters:
<SSM>
18.17.11.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1422
●
BUS<m>:SYMBols on page 1423
BUS<m>:ARINc:WCOunt?............................................................................................1639
BUS<m>:ARINc:WORD<n>:DATA?............................................................................... 1639
BUS<m>:ARINc:WORD<n>:LABel?...............................................................................1640
BUS<m>:ARINc:WORD<n>:PATTern?........................................................................... 1640
BUS<m>:ARINc:WORD<n>:SDI?..................................................................................1640
BUS<m>:ARINc:WORD<n>:SSM?................................................................................ 1641
BUS<m>:ARINc:WORD<n>:STARt?..............................................................................1641
BUS<m>:ARINc:WORD<n>:STATe?.............................................................................. 1641
BUS<m>:ARINc:WORD<n>:STOP?...............................................................................1642
BUS<m>:ARINc:WORD<n>:SYMBol?............................................................................1642
BUS<m>:ARINc:WCOunt?
Returns the number of decoded words.
Suffix:
<m>
.
1..4
Return values:
<FrameCount> Range: 0 to 100000
Increment: 1
*RST: 0
Usage: Query only
BUS<m>:ARINc:WORD<n>:DATA?
Returns the data of the specified word.
Suffix:
<m>
.
1..4
Protocols